LINK TO PART 2: https://www.youtube.com/watch?v=dyBhd66lY9I
If you know your top is not leaking, or if you have replaced your top and the roof is still leaking, here is a DEFINITE FIX. DETAILS BELOW.
1) Take out rear seat: 2 push-pins you need to push to release bottom of rear seat, each are under the middle of each seat. Put your fingers between the carpet and the seat and feel around, push the button in, and release seats.
2) Take out rear back-rest. 2 bolts with a ratchet in plain view. Then, when unbolted, push back-rest UPWARDS to unhook hinges that are near the top of the back rest, then pull out.
3) Remove plastic side-panel. When you open the door, that piece of plastic above where it says Mustang, needs to be removed so you can access more of the carpet to pull it up. Just pull it up with a trim-removal tool.
4) Use a Torx-45 (pretty sure) to remove your FRONT seat belt bolts. DO NOT turn the wrong way, make sure youre pushing the wrench towards the ground, not pulling it up or you’ll snap the bolt and then your DIY career ends. The bolt needs to turn LEFT!
4) Remove Seats. Straight forward, 4 bolts, simple ratchet. Motor assembly wires for driver’s seat just unclip easily.
5) Peel carpet as FAR to the middle as possible so you can see the entire weld covered in factory sealant from FRONT TO BACK.
6) Seal with whatever urethane, rubber, other sealant you or a professional have chosen SPECIFICALLY for TEMPERATURE RESISTANCE, WATER RESISTANCE AND FLEXIBILITY.
7) LET DRY!!!
***DUCT TAPE LINK FIX I TALKED ABOUT IN THE VIDEO https://www.youtube.com/watch?v=C21EcaTRefQ *********
Post time: Jun-26-2017